Dell Wyse WES7 conversion kit for Z class Guía de instalación descargar pdf (Pagina 8)

4 Chapter 2

Figure 2 Removing the cover screws

4. Place your thumbs on the top surface above where the end screws were removed.

With a continuous motion, push firmly downward and towards the back panel (pushing

down unlatches the hooks under the cover). The cover will shift approximate 1/4 inch to

hang over the back panel, as shown in Figure 3.

Figure 3 Unlatching the cover

5. (a) Grasp the overhanging cover edge and raise the edge

about 1-1/2 inches, and then (b) pull the cover out towards the back panel at the same

angle to free the opposite end of the cover from the remaining hooks, as shown in

Figure 4.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Sin comentarios

Dell Wyse WES7 conversion kit for Z class Guía de instalación Pagina 8